This site will look much better in a browser that supports web standards, but it is accessible to any browser or Internet device.


Clubs, glossaries, museums, shops and much more......

glue-it.com

...all of your model making needs from one site.







Model Engineering Glossary: A B C D E F G H I J K L M N O P Q R S T U V W X Y Z

Pipe Bending

This picture shows the pipe bender assembled and have just finish bending a 90 bend in a pipe.


With the arm that is used to bend the tube removed you can see a bobbin that was turned with a semi-circular groove to take the pipe.

You can also see the supporting brass blocks that hold the pipe fixed at the end that doesn't move.


As I found out very quickly it is important to get all of the parts of the pipe bender fitting tightly so as to give as much support to the pipe as possible.

You can see the brass blocks pushed as close as possible to the aluminium bobbin.


One of the copper pipes with the bends in place.

The pipe was cut to length after the bends were made as this is not an exact process.


Model Engineering Glossary: A B C D E F G H I J K L M N O P Q R S T U V W X Y Z