This site will look much better in a browser that supports web standards, but it is accessible to any browser or Internet device.

Clubs, glossaries, museums, shops and much more......

...all of your model making needs from one site.

TiN End Mill

I needed some new end mills as I managed ot break an 8mm one last week - quite frankly I was being heavy handed and had not tightened up some of the traverses as well as I should have. I went online to one of the regular places that I purchase this sort of tooling from and saw that they were selling TiN coated end mills at around 2.50 each.

TiN is the chemical abbreviation for Titanium Nitride, a hard ceramic material that is added as a coating to high speed steel to improve wear resistance, for edge retention and corrosion resistance on machine tools.


I′ve been machining a bearing block for my beam engine, a phosphor bronze casting and must admit that it wasn′t going that well. I was using one of my old end mill bits and it really did feel like the edge had gone.

I swapped the end mill for one of the new ones I had just received, 6mm with a 6mm shaft. You can just see the end of the collet with it held in the mill.

The change in the cutting performance was quite frankly remarkable with me being able to double the depth of cut and increase the feed rate.

In addition the finish looked much better. OK, some of this was just down to the fact that it was a new sharp end mill, but do think that TiN coating improved the cutting performance.

Price: approx 2.50 for a 6mm end mill


Great price and must admit that I wouldn′t buy any milling bits without the TiN coating.

Available at

This is an end mill that has had some use on steel and aluminium and you can clearly see the rounding of the edges.

These end mills are widely available from many different online retailers in the UK and are at a very low price and so be prepared to replace them quite regularly.

See also: End Mills, Maykestag End Mills, Tools.