Ben′s site is nolonger online, but if you search for “Ben Peake engines” you will get lot’s of images of the engines he has made . Time to stop browsing and off to the drawing board….
The flywheel casting is the 3.5″ Stuart Turner one as used on the Stuart 10V engine. As you can see, I machined the flywheel down to a diameter 77.5mm and width of 10mm.
Also, I machined the spokes thinner as well as the rim.
I wanted this to look like a lamp post and so that′s what I machined from steel in two parts.
The base is 20mm diameter and so roughly 60mm in circumference, with a 3mm bullnose end mill this would mean I needed 10 flutes.
The cylinder was machined from phosphor bronze with 15mm bore and is roughly 30mm long. The piston was machined as a bucket and then the gudgeon pin fitted in blocks that were then soldered with the small end of the connecting rod fitted. I will need to unsolder this if I need to change the small end.
The valve pushrod was made with a mild steel outer eccentric ring and then using 2mm square brass tube I solder together this lattice.
There is a small brass bearing in the bottom end of the pushrod.
The valve block itself looks a bit like a whistle.
These valve blocks are easy to make, but be prepared for some time setting it up and getting it working. I had no adjustment screws and so had to machine the valve slightly to get the timing working correctly.
The ends are threaded 6BA to fit the end bushes.
The cylinder, valve block and post are all soft soldered together.
The lower rod through the post that connects the cylinder and valve block was drilled and is the main connection for steam inlet and exhaust.
The eccentric was milled out using a rotary table – it was rather heavy from solid brass and so needed to lose some weight.
There is a grooved turned in the eccentric and the screw you can see has a point that locates in this groove.
Must admit that I did not make the globe valve, bought this from Steam Fittings (steamfittings.co.uk).
I must admit that I’m never quite sure whether I should add a light to the top of the post and a generator running off the flywheel to power a small LED. The base is a piece of wood machined to look like a road with a gutter, brass drain cover and a kerbstone and path.
More of my engines are in my gallery page.