Glanze Profiling Tool

I bought this to use on the Warco WM240b lathe.

The tool comes with a torx key, but no space insert. Although being round you can rotate the insert and so re-use more of the cutting edge before giving up on the bit.

A close up of the insert shows the fine edge and the slight serrations on the inner surface to break chips.

Here it is compared to the Glanze TCT that I bought previously.

The thing that surprised me when this arrived from Chronos was how short the tool is overall.

The main body of the tool does suffer quite a lot of damage from the tool clamps. This surprised me at first, but I’m used to using solid HSS bits and these Glanze tool holder bodies are much softer.

The tool is quite short if you want to hold it at the extreme points of the toolholder. However, the tool is stiff enough to be held just by 2 of the fixing points.

The tool holder is a tad on the short side, but having said that this is a great tool to have for turning cast iron.

Price: approx £22 for the 12mm tool and £4 for a spare 6mm diameter tip.

The finish you get with the tool is fantastic. I used it to face and finish a cast iron piston and the result was stunning.

Available at glanze.co.uk

 

 

 

About Nigel 173 Articles
Have been making models since I was around 7 years old and using a lathe from the age of 11, a self taught engineer with a passion for making model engines.

Be the first to comment

Leave a Reply

Your email address will not be published.


*