3 Jaw Chuck Runout

I’m getting significant 3 jaw chuck runout on my Warco 240B lathe. Although ok at first I’m now finding the chuck as delivered with the lathe is rubbish. As delivered the Warco 240B lathe and the 3 jaw chuck were brilliant, but over time the runout on the 3-jaw has increased. I’ve even marked the … Read more

Warco WM240b Carriage

I’ve had a Warco WM240b for a number of years, but in the last few days the main carriage has been developing noticeable play. The obvious sign was that I would make a cut and the tool would make another cut as I backed off. My first port of call was to look at an … Read more

Switch Failure on Warco WM240B

There was no bang or sparks or smoke, I switched the Warco WM240B lathe off and it just would not restart, a complete switch failure on Warco WM240B. I did all of the usual things of checking that there was power at the main plug and that the fuse was intact and all was fine. … Read more

Lathe Tools

lathe tool height and angles

The lathe tools are held in a toolpost on the lathe cross-slide and which are then fed into the rotating workpiece to machine it to size. Lathe tools are made from high speed steel (HSS), Tungsten Carbide or other very hard materials such as diamond. Angles and Clearances The cutting and clearance angles of a … Read more

Warco Lathe Stop

I’ve been using my Warco WM240B lathe for a number of years and although I’m not a great admirer or saddle stops I thought it was about time I made one.   The starting point is a piece of square cast iron. I marked a line with a square and a pencil, as you can … Read more

Soba Tailstock Die Holder

A review of the Soba Tailstock Die Holder. Normally I use a standard handheld die holder and push this against the bar to be threaded with the tailstock and then start to cut the thread. This can be very hit and miss, but normally this works well. So the idea of £33 for a purpose … Read more

Centre Drill Profile

warco wm240b tailstock

A look at the Centre Drill Profile. I use centre drills all of the time, usually as a pilot drill in the lathe to give me a good starter for a larger drill. However, why are they the profile they are? A combined countersink and drill used to prepare work for mounting centres. Also used … Read more

Warco ER25 Lathe Collet Chuck

A review and assembly of the Warco ER25 Lathe collet chuck. When you buy the collet chuck you have to buy a backplate for your particular lathe. In this case for a Warco WM240B. The backplate is made from cast iron and was pre-machined to fit the spindle of the Warco WM240 lathe and also … Read more

Anatomy of a Lathe

warco wm240b lathe saddle

Just bought a lathe and feeling a touch in awe of it? The first thing then is to familiarise yourself with what is what around the lathe? This particular lathe is a Warco WM240B (review of the WM240B). This is a good size for a general purpose hobby lathe with a maximum swing of 240mm … Read more