1/8th Scale Cake Shop

miniature cake shop
miniature cakes

This miniature 1/8th Scale Cake Shop was made some time ago by Nigel Taylor and Eileen Careless.

The 1/8th scale cake shop was designed to hang on the wall as a 3 dimensional picture. The shop itself is just 80mm deep with a board at the bottom protruding a further 50mm that forms the pavement at the front of the shop.

The main body of the shop was made from 3 layers of 3mm ply. It is worth purchasing a good quality plywood to ensure everything is square. Also, it’s easier to work with.

Bricks

The bricks were made using air drying clay that was rolled into thin sheets and glued to the plywood carcase using PVA glue. This needs to be done whilst the clay is wet. The clay was covered with cling film (food wrap) to stop it drying too quickly. The thin line of concrete between the bricks was marked out using a strip of wood. Once all had been marked out the cling film was removed and the clay allowed to dry. Any wrinkles in the cling film help improve the overall effect.

Bay Window

miniature bay window

The wooden frame of the bay window was constructed from machined hardwood and carefully glued together in the opening left in the shop.

The bay window was glazed with 1.5mm thick glass. It is difficult to make plastic look as authentic in this situation, but it is safer if little hands are likely to get close. The glass was held in place using thin beads of silicon.

The door frame was machined from hardwood and again glued into the opening left for it.

When all was dry the wooden frames were given an undercoat, left to dry and sanded with fine wet & dry paper and again undercoated. This process of undercoating and sanding was repeated until an acceptable finish was achieved. The frames were painted in gloss white paint and left to dry thoroughly. A thicker coat of paint just adds a level of realism.

inside and outside the cake shop

The next job was to prime the bricks in grey. This also gave the initial coat to the cement layer between the bricks.

The bricks themselves were painted with acrylic paint. Initially a base brick red and then with different shades of red to add some authenticity.

This part takes a lot of time as the more carefully and slowly you add the different shades the better the overall finish.

Glazed Door

The door was hinged and a simple latch constructed that is worked by the door handle.

Again the door was glazed, this time with 2mm thick glass that was etched using a glass etching kit sold for etching car glazing. The glass was first cleaned using soap and water and then the design applied using Letraset. The Letraset stops the etching liquid from attacking the glass. After the time specified for the etching fluid it was carefully washed away before the Letraset was removed.

Letraset now feels like it has had it’s day and not so easy to acquire. A good replacement is Cricut, an adhesive vinyl that can be cut/printed to your design. Clean the glass thoroughly before applying the vinyl lettering/design to the areas you want to resist the etching.

https://www.cricut.com/
inside the cake shop
Looking out of the 1/8th Scale Model Cake Shop at the Ford Model T

The rear panel of the cake shop was made detachable so that the shop could be accessed and a glass panel forming the ceiling of the shop allows lots of light in.

The cakes were made from Fimo. No further comment will be made on how the cakes were made as these deserve an article in their own right. There are lots of other details in the shop that add to the authenticity such as the wooden floor boards, shop counter, shelf on the inside of the front wall with a basket on it and other items such as the glass shelves in the bay window.

About Nigel 338 Articles
I've been making models since I was around 7 years old and using a lathe from the age of 11, a self taught engineer with a passion for making model engines.

Be the first to comment

Leave a Reply

Your email address will not be published.


*